Ping me if you’re familiar with NEST thermostats!
Brand new HVAC and ductwork in Feb 2018.
No obstructions in drain
Thermostat sees all 6 wires DURING failure
Had the same Nest the life of the system from day 1
For the past few days, once daily, the Nest Gen 3 t-stat will stop blowing cool air in the middle of the cooling cycle, prior to reaching the set temp. It will still say “Cooling” but the air will start blowing warm. This does not resolve until the Nest is pulled from the wall plate for a few seconds and placed back. Then it counts down and resumes blowing icy cold like nothing happened. (Simply switching to Off then Cool does not get cold air blowing again.)
Has there been a new firmware release? Anyone else experience this?